2013 Annual Merit Review Proceedings

Hydrogen Production and Delivery

View presentations and posters from the Hydrogen Production and Delivery session at the Annual Merit Review in May 2013.

Hydrogen Production Session Introduction, Katie Randolph, U.S. Department of Energy

Hydrogen Delivery Session Introduction, Erika Sutherland, U.S. Department of Energy

Hydrogen Production and Delivery Presentations

  1. Hydrogen Delivery
  2. Electrolysis
  3. High-Temperature Thermochemical
  4. Photoelectrochemical
  5. Biological

A. Hydrogen Delivery

  1. Hydrogen Delivery Infrastructure Analysis, Marianne Mintz, Argonne National Laboratory
  2. Oil-Free Centrifugal Hydrogen Compression Technology Demonstration, Hooshang Heshmat, Mohawk Innovative Technology Inc.
  3. Development of High Pressure Hydrogen Storage Tank for Storage and Gaseous Truck Delivery, Don Baldwin, Hexagon Lincoln
  4. Fiber Reinforced Composite Pipelines, Thad Adams, Savannah River National Laboratory
  5. Hydrogen Embrittlement of Structural Steels, Brian Somerday, Sandia National Laboratories
  6. Electrochemical Hydrogen Compressor, Ludwig Lipp, FuelCell Energy, Inc.
  7. Vessel Design and Fabrication Technology for Stationary High-Pressure Hydrogen Storage, Zhili Feng, Oak Ridge National Laboratory
  8. Rapid High Pressure LH2 Refueling for Maximum Range and Dormancy, Salvador Aceves, Lawrence Livermore National Laboratory
  9. Polymer and Composite Material Performance in Hydrogen, Chris Moen, Sandia National Laboratories

Back to Top

B. Electrolysis

  1. PEM Electrolyzer Incorporating an Advanced Low Cost Membrane, Monjid Hamdan, Giner, Inc.
  2. Renewable Electrolysis Integrated System Development and Testing, Kevin Harrison, National Renewable Energy Laboratory
  3. High Performance, Low Cost Hydrogen Generation from Renewable Energy, Katherine Ayers, Proton OnSite
  4. Low Cost Large Scale PEM Electrolysis for Renewable Energy Storage, Katherine Ayers, Proton OnSite
  5. Economical Production of Hydrogen through Development of Novel, High Efficiency Electrocatalysts for Alkaline Membrane Electrolysis, Katherine Ayers, Proton OnSite

Back to Top

C. High-Temperature Thermochemical

  1. Electrolyzer Development for the Cu-Cl Thermochemical Cycle, Michele Lewis, Argonne National Laboratory
  2. Solar High-Temperature Water Splitting Cycle with Quantum Boost, Robin Taylor, SAIC
  3. Solarthermal Redox-based Water Splitting Cycles, Al Weimer, University of Colorado at Boulder
  4. Solar Hydrogen Production with a Metal Oxide Based Thermochemical Cycle, Tony McDaniel, Sandia National Laboratories

Back to Top

D. Photoelectrochemical

  1. Solar Hydrogen Production by Photoelectrochemical (PEC) Water-Splitting: Advancing Technology Through the Synergistic Activities of the PEC Working Group (PEC WG), Thomas Jaramillo, Stanford University/NREL
  2. Semiconductor Materials for Photoelectrolysis, Todd Deutsch, National Renewable Energy Laboratory
  3. Photoelectrochemical Hydrogen Production, Jian Hu, MVSystems/HNEI
  4. Critical Research for Cost-Effective Photoelectrochemical Production of Hydrogen, Liwei Xu, Midwest Optoelectronics, LLC
  5. Characterization and Optimization of Photoelectrode Surfaces for Solar-to-Chemical Fuel Conversion, Tadashi Ogitsu, Lawrence Livermore National Laboratory/NREL

Back to Top

E. Biological

  1. Maximizing Light Utilization Efficiency and Hydrogen Production in Microalgal Cultures, Tasios Melis, University of California Berkeley
  2. Biological Systems for Hydrogen Photoproduction, Maria Ghirardi, National Renewable Energy Laboratory
  3. Fermentation and Electrohydrogenic Approaches to Hydrogen Production, Pin-Ching Maness, National Renewable Energy Laboratory
  4. Hydrogen from Water in a Novel Recombinant Oxygen-Tolerant Cyanobacterial System, Phil Weyman, J Craig Venter Institute
  5. Probing O2-tolerant CBS Hydrogenase for Hydrogen Production, Pin-Ching Maness, National Renewable Energy Laboratory

Back to Top

Hydrogen Production and Delivery Posters

  1. Hydrogen Delivery
  2. Separations
  3. Distributed Bio-Derived Liquids
  4. Electrolysis
  5. High-Temperature Thermochemical
  6. Photoelectrochemical

A. Hydrogen Delivery

  1. Development of a Centrifugal Hydrogen Pipeline Gas Compressor, Frank Di Bella, Concepts NREC

Back to Top

B. Separations

  1. Bio-Fueled Solid Oxide Fuel Cells, Gökhan Alptekin, TDA Research Inc.

Back to Top

C. Distributed Bio-Derived Liquids

  1. Distributed Bio-Oil Reforming, Stefan Czernik, National Renewable Energy Laboratory

Back to Top

D. Electrolysis

  1. Unitized Design for Home Refueling Appliance for Hydrogen Generation to 5,000 psi, Timothy Norman, Giner, Inc.
  2. Hydrogen by Wire – Home Fueling System, Luke Dalton, Proton OnSite
  3. Low-Noble-Metal-Content Catalysts/Electrodes for Hydrogen Production by Water Electrolysis, Katherine Ayers, Proton OnSite

Back to Top

E. High-Temperature Thermochemical

  1. Electrolyzer Component Development for the HyS Thermochemical Cycle, William Summers, Savannah River National Laboratory

Back to Top

F. Photoelectrochemical

  1. PEC Materials: Theory and Modeling, Muhammad Huda, University of Texas at Arlington
  2. Metal Oxide Semiconductor Nanotubular Arrays for Photoelectrochemical Hydrogen Generation, Dev Chidambaram, University of Nevada Reno
  3. Photoelectrochemical Material Synthesis at LANL, Todd Williamson, Los Alamos National Laboratory
  4. Next-Generation Si Microwire Array Devices for Unassisted Photoelectrosynthesis, Shane Ardo, Caltech

Back to Top

To locate posters and presentations from other meeting sessions, go to the main page of the 2013 Annual Merit Review Proceedings.